Good design. Solid print. This will likely fit most benchtop jointers, but is a little too small for my Delta 37-196 (6” floor standing). The dimensions are approximately 7 1/4” long x 3 3/4” tall (~184mm x ~96mm).

The first attempt had wicked bad uneven top surfaces. I had to adjust a few settings from the profile to slow the top layers and do some ironing. But once I did that it came out perfect.

holds four Rockler Bandy Clamps (M).

Sturdy, prints quickly. Filament = SUNLU High Speed PLA Green

The holes were too tight straight off the printer, but nothing a few passes on the spindle sander couldn’t fix. (Filament = Polymaker Silk PLA in Lime Green)

Perfect for long writing utensils, like Blackwing pencils.

Good push stick, but the handle is too short for my gorilla paws. Scaling upward to increase the size of the handle would make the push stick too wide to be useful in tight cuts (which is where a push stick is needed most).

Great print. The double wall profile produces reasonably stout pyramids while still being economical with the filament usage.

Fits my Festool MFT like a glove!

Great print. Fits every one of my DeWalt cordless drills/drivers, from the compact 12v to the chonky 1/2” (13mm) hammer drill (DCD996). Also fits Milwaukee 12v drills *with* belt clip. Unfortunately does NOT fit Festool CXS 12 (though I haven’t yet found one of these “universal” holders that does.)

Great print! I appreciate the divet that facilitates rocking the knife up for easier grabbing.

Economical use of filament, yet still sturdy.