amberrose0214

TomczukCustoms

Printed it with 100% size with PLA Green/Black Magic Silk from Rosa3dAlso printed 80% size with PET-G Glassy from Spectrum.Both were printed on P1S 0.4 nozzle, 0,2 layer height.I didn&#39;t have any problems with parts sticking to other parts (after a few tests of course ;) )Snake moves smoothly right after printing.NO SUPPORTS are needed ;)I didn&#39;t use brim and print turned out just great. If you like it please share your make ;)UpdateI printed two more snakes to test if there is an any issue. There was no problem printing   either off  them. 150% scale in X and Y and 120% in Z (looks more real to me in that scale). The tiny one was 50% in XY and 40% in Z.&nbsp;Have a nice day!!!

Articulated Snake!!! Print in Place, No Supports;)

articulated 

Meyerhouse

A fishing lure that works even better!! Don&#39;t buy expensive crankbait that you hate to use because you think you are going to get hung up on something throw 20 bucks in the lake. Print these and you don&#39;t have to worry. Color it any way you would like. I used nail polish after I super glued the eyes and black dot or don&#39;t. Just some 9mm split rings and some # 6-8 treble hooksThe split rings actually measure out 9.4mm (.370&#34;) OD and 6.85mm (.269&#34;) IDat pauses add them in.

FAT SHAD CRANKBAIT

fishing gear 

V3T3D Designs

What&#39;s up Jeep peeps! Have fun with this keychain model of the Many Ducks. &nbsp;May need to slow this one down and make sure you have really good bed adhesion.

articulated

fishing gear

jeep ducks