alamondm

Hyrex_

A cable puck organizer fits this cable puck by "Everydecentnameistaken" on printables: <a target="_blank" href="https://www.printables.com/model/55627-cable-puck-print-in-place-cable-management" rel="nofollow noopener">https://www.printables.com/model/55627-cable-puck-print-in-place-cable-management</a>You can fit a total of three pucks into the tray to keep them in reach but without the mess ;) &nbsp;Im using a lightning, usb-c and usb micro cable but the model is expandable in the slicer itself and can be stretched to hold an indefinite amount.

"Cable puck tray" for print-in-place cable management cable pucks by "Everydecentnameistaken"

Cords

Toxvaerd

<h2>Summary</h2>this is a fine model of an F22 Raptor not much more to say. the rudders can be pretty hard to print so maybe try scaling it up. hope u enjoy it(I have updated the print profile as many had problems. There are now connectors added to the model, you may need to sand/debure the connectors a bit. another tip is to cut off the tip of them so they fit easier :). )&nbsp;Any feedback is appreciated.

f-22 raptor (detailed) 

Jets

Yazza

A simple 18650 battery case for two batteries, with a functional print-in-place hinge and a clasp strong enough for regular use. The clasp orientation is suboptimal due to print restrictions so if subjected to unusual stresses would snap, but works well when used appropriately.

Cords

Jets

Misc