I absolutely love this model. I printed it large and put it in my lewisi iguana enclosure. I also printed one in glow for a friend, and it is incredible

you will not be disappointed with this print. Prints nice and looks great

This a nice print. I made it larger and used it in a reptile tank

printed this for 4 ams and work well

This printed nice, had a harder time finding a dragon to fit inside of it.

This is nice, easy to print model. Made a few to give out to my friends with Geckos and they love it.

Print nice and clean and look great!!!!

I printed these to put small plants in my lizard cages and friends had to have me print them one as well. I need to have a file that does not have drain holes so I can put treats in them for my lizards. Love the look of them

This printed nice but I wish the walls were sturdier. I am sure there was a setting to change to make it heavier but did not want to screw up the lid fitting. It looks good and prints clean.

absolutely love these and the print comes out clean

This is one of the best coaster holders I have ever printed. Sturdy and clean print

This hat prints nice and is a great keychain

print nice and easy to read

Print nice and clean

These print nice and clean with no filament color bleeding.

I printed this for St. Patrick's day ad still have it sitting on my shelf.

This a cute keychain and the detail came out nice. Print a bed full to make it cost effective as they make great gifts

I printed this for a Uromasyx lizard. I resized it and made the opening bigger. It does the job, but is there a way to make it thicker? Wish it was more sturdy and heavier as it moves easily even though I tried to bury it in gravel.

This bowl printed nice, but concerned with the leftover support under the inner lip. I think it would be easy for superworms to climb out, but not sure. I scaled it up and that was not a good idea. Way too deep for a lizard to get anything out of it.

These are great, I have 4 ams ad printed 16 of each type of filament that I use, It is great for seeing what filament is where without having to open the lid and look for a label. I did adjust the base part a little smaller just to make it easier to slide on and off, but that was just me.