I needed a trim kit for my deck posts which had already been installed. A trip to my local hardware store yeilded no results for a kit that could be installed on an existing post, so I made one. I only needed a simple design so I came up with this one. I hope others find it useful.

I needed a case for my ESP32-DEV board and needed room for components. I couldn't find case I liked, so I made one. I have the openscad file but it still needs tweeking so it's not available yet. The circut board is from amazon. https://www.amazon.com/dp/B09BCT2T8W?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_7. I cut it half lengthwise and the used an xacto knife to scratch away a line down the center so I could solder my own jumpers. I have deployed 3 of these and they work perfectly for me.

I needed a holder for the oil and grease I use for my P1S but couldn't find anything so I created kinda quickly and it fits my needs. Hopefully it fits yours as well.