aerospace2020

addohm

A raspberry pi 5 case, paintable logo, vented, access to DSI and PCIe ribbon cables, access to GPIO, fits the official active cooling. Keep your eye out for additional variants including side access. Supports are not necessary however if you plan to use the DSI slots it shouldn't but may make them a little tight depending on your overhang tuning.EARLY Pi5 RECIPIENTS: Please give feedback as I won't be able to aquire a new pi for at least a couple weeks.Note: The Raspberry Pi logo is paintable. If you do not want the logo, just dont paint it and it wont appear on your print.&nbsp;&nbsp;Update 23Oct23: Opened up snap fit to make it less tight. Added more chamfer to screw holes. Added Toolless variant.Update 24Oct23: Changed snap between USB ports to be a solid flat surface as the snap fit could potentially break there with too much force.

Raspberry Pi 5 Snap Fit Vented Case

work

Deviian

Model of a splitter for AMS Lite designed for using an external spool without constant disconnecting of the PTFE tube.&nbsp;Designed for PTFE tubes with an outer diameter of 4 mm and an inner diameter of 2.6 mm. Same as used by BambuLab.The openings for PTFE tubes are intentionally tighter; try to insert the PTFE as deeply as possible."<ul><li>It is designed above the print head (see the photo, the length of the lower tube is approximately 40 mm).</li><li>Before installation, it is necessary to disconnect all PTFE tubes and thread them through the splitter."</li><li>It is necessary to insert the tubes firmly into the splitter to avoid tube falling out or filament jamming. Be cautious about tube crimping or potential breakage.</li></ul>When not using an external spool, it is necessary to have the filament retracted outside the splitter. This will clear the path for filament from AMS. When using an external spool, it is necessary to do the same, simply rotate the filament spool.

work

A1 Accessories