I experienced my first #clog 😭 Its my first printer have printed at work before. This one has been printing for the past 7 days with no issues until I think i printed with the wrong material setting? I have PLA Matte, i noticed it was set to PLA Basic in the print. and it was a super fine print setting with 0.08 layer and 0.1 thick. I did 2 tiny models on the same plate, each printed by object. 1st was nice, 2nd one #clogged tf out of it 🥲 I need to ask for the community's best practices on how one should clean the #hotend heating module, or just leave it and pray for the best? The nozzle was easy, especially on #P2S, it just pops out :P