perfect print. cannot recommend enough, printed with 0.6mm nozzle at 0.42mm layers, printed in ABS with no supports, 100 degrees on a biqu cryogrip glacier. printed one male and one female in 2hrs 15 minutes.

Super sharp, especially with the least bit of sanding. I use a bevel side down, and make sure to never ram it into a part that is stuck, I only use it under a part that has started to come loose as a wedge to help gently lift it. If you use it for its intended purpose it's very good, and durable. You can see that even after losing a corner it's still has great functionality, And even after I lose that entire layer, It will still be a great scraper if not quite as sharp.

Printed flawlessly. Read the instructions, and gently rock the grippers free, i was amazed.

wonderful print. nice size, right in between large and small.

came out great.

amazing!

came out perfect.

I may have slightly under extruded the filament assigned to the soil, but the carrots kept popping out, so I wasn't really able to get very many pristine looking ones. hoping the next round with calibration will be better.