Printed pretty good. The buttons don’t work particularly well, but I’m guessing that isn’t the models fault. I plan to try in PETG instead of PLA

Love this spinner. Tried a few and this is my favorite

Spins well. Came out great

Works well

Great print! After printing 20 of them, I’ve got some tips to avoid breaking the legs: 1. Star by pulling off the brim with your hands. it should come off relatively easily. The supports protect the legs at this stage, but if you do the brim later, it can tip the legs off 2. detach the front and back supports from the body. I prefer pliers for this. 3. Carefully twist the supports loose. They usually come off fairly easily, but once in a while they can damage a leg

Helpful!

Great modification! I'll be using these to fill my drawers, likely with some modifications to lighten the amount of filament used. The costs on this adds up quickly even with just 1 or two Alex drawers

It's Benchy

Perfect modification!

Great kit! The engines are a bit more fragile to snap on and would benefit from glue.

Works great for what it is! I didn't end up using this for my drawers, as it would make picking a container up out of the drawer more difficult and prone to dropping the smaller containers