Fast. Easy to make. The supports inside the balls are a small pain to get out. A super good time to use PLA or PETG for tree interface.

when he suggest upsizing by 1 mm pay attention…i was stingy amd ended up tapping them on with a hammer

if I do it again I will try to modify the screw to be longer. i could not screw in between the ribbon with my huge fingers. Also, my fault I almost broke it removing from the plate because the one I printed has a thin bottom. Screws all work great but something to be aware

they work great for me. a small trick - Inplace dessicant in a large ziploc bag and scoop to fill larger side of the puck. pouring (for me) was messy

the hollow one prints way faster and looks as good I think

works fine. reading the instructions helps ha ha. the supports on the little piece that travels made a fool of me but if you watch video you can avoid my mistake. i printed in translucent petg and had zero problems. By end of first roll all the little sticking points were smoothed out.

zero problems. i don’t know how well they work without a locking shim but with a locking shim it is great.

they work fine

scaling it up 100% makes a solid large box. great print. no problems with ribbon when scaling.

very clean, no supports needed, looks great

flawless build. the supports tweaked so they come off easy. the ribbon snaps on cleanly. it is optional, I used few drops of glue to make sure ribbon & bow don’t fall off.

Be careful removing trees, some of them are on small pieces like the sword. (I printed for a friend so I have not idea if this is a good likeness. She was happy though)

And remind people to dry PETG.. my first prints w/ PETG (Bambu version) and the fails 48 hours out of the dryer is stupidly amazing.

Had zero problems printing on h2s. I would suggest considering a note about supports able to be turned off. i printed ‘no supports’ and it was fine. Now wondering if I can print at 80% and 120% and have everything work snapping together…It should. Guess I will know in day or so…

I have made three of these. And all three have been taken from me by children.

ingenous design approach and good tolerances. these keep being “taken”. people love these

very popular. i have printed two and they just generate giggles and smiles