this printed out super easy… supports were large and came off easy. needed to clean up support attachment points at a few tight edges… but it looks great. will post pics after painting.

super easy print. did leave a few holes along the sides. I did enlarge it 50%. perhaps that’s why… but easy enough to seal/cover up with a bit of glue on the inside.

very clean print…very easy to peel supports. great look. I think a little smaller than I intended… would recommend 20-50% bigger. (🤷‍♂️).

very easy print… very clean… supports came off very easy. I probably should have reduced size… will work as terrain… but oversized for my dungeon tile sets…

super easy print… came out clean… I will use them as rope climbs to different dungeon or cave levels in DND.

super easy print… I did 6-7 of different sizes. I will use mine in a moonscape map for DND. will submitted pics when painted.

I printed 2… one unsupported… one supported. both were either bad prints, or tough to peel all the supports. but I do love the look. took like 20 hours supported. I will use them in a Golden Orchard in my DND fey-wild campaign.

these are really cool. not sure if I should have reduced them… but I’ll use them for dnd. I will submit more pics when painted… be careful peeling supports around hammer and hands. easy enough but I got sloppy.

these are cool… printed out 6-7 … I envisioned them as desk being used by acolytes or priests to copy/produce texts/books. very easy to paint and get in the board.

I loved this… could be enlarged or shrunk to fit multiple applications… will run mine as the monster in a labyrinth in the Fey-realm. (DND) super easy to print…supports came off easy, no fingers to lose 😜👍.

really cool. gonna paint em up to be some devilish fey creatures.

these are great… printed out 2 sets to keep on hand.

So, as soon as this finished printing I thought… well it’s super cool… but maybe 10-20% too big. But now after putting miniatures next to it… I think all my other terrain is too small. can’t wait to paint this. Hope this helps the next printer decide on a size for them. Would Strongly recommend!!!❤️👍

I love that this is a chonky and simple print. it’s perfect for either a terrain piece or as a monster. I plan on using it as a monster that pulls characters into it to…for a long horrible digestive process. but it could also be a Druidic NPC, or a portal to the Fey… thanks! (could also be painted much better, but I needed a corrupted swamp tree. so the black was a choice)

I printed up about 4X the original amount...cant wait to get them on the DND tabletop as some scatter terrain in the corners of dungeons...or at a merchants warehouse...or around the blacksmiths shop....Love em. I did shrink them to about 50% of the original size to match my games scale.

I really dug this little puzzle…. I think anyone printing this should enlarge it a bit…maybe 20%. I did not multi-color print this… I dry brush painted with some rune highlights… anyhow, very effective. I will use it as a magical door lock to challenge my rogue player in DND.

these will make great minions for my “corrupted forest” campaign. some easy dry brushing and a little highlighting… muah… perfect.

I printed 2 of these for my faantasy town… very easy to print… super easy to paint. I love them. I think I might’ve messed with the size a bit to match my DND scaling. 👍

I love this model. it’s a little blurry because I enlarged it quite a bit… but it’s super effective… and 2-3 of them will make for a cool open market battle map.

love these… think I will need to use blue tack on the bases though, as I build uneven and unsturdy maps with texture… but I love the chain link design!