Uvatha

EPIQ3D

UPDATE 08 June 2024:Pistachio Bowl 2.5 has been released - <a target="_blank" href="https://makerworld.com/en/models/488822#profileId-404395" rel="nofollow noopener">check it out here</a>--------------------------------------------------------------------------------------------------------- — No support needed — — A pistachio bowl reinvented — Unique stylish design, crafted to be used, but also seen.2 in 1 function. Complete the collection, and check out the bowls little brother - Pistachio Cup So, how does it work, whats so speciel.Well.. not much ;) but the idea is, that when you dispose of the empty shells, you put them in the hole (nothing new there).BUT- when the spot beneath gets overcrowded of sheels, dont rattel the bowl - just turn the top to a new spot.If shelled nuts is not for you, then the bottom part can also be used as a standalone bowl And, its pretty … Holds about 250 grams

Pistachio bowl 2.0

bole

SaVo3D

<h2>This my remote control holder with 4 departments!</h2>You no longer have to look for the remote control all over the living room. Store them at your table in this holder.&nbsp;The print is possible without AMS! The body and side walls are on separarate plates.After printing, simply slide in the walls. No gluing necessary!<img src="https://makerworld.bblmw.com/makerworld/draft/503431/2024-01-23_e6b4c3bece85.png">&nbsp;Print instructions:<ul><li>layer height 0,20mm</li><li>3 wall loops</li><li>top/bottom shells 4 layers</li><li>top/bottom shell thickness 0,80mm</li><li>sparse infill 10%</li><li>sparse infill pattern “gyroid”</li></ul>Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design!&nbsp;If necessary, cut off a little bit of the edges as shown in this picture:<img src="https://makerworld.bblmw.com/makerworld/draft/503431/2024-01-23_85c52eb6e657b.png">&nbsp;Update 06.02.2024: by user request i uploaded a version with a wider last department. The last department of the new version is 45mm deep. The new print profile is named "wider last departmet".

Remote control holder 4 departments

holder

Ruvim KUB

<h2>Epoxy resin glue tray with spatula</h2>&nbsp;I tried to make all the walls very thin to save plastic. Also for a nice organization of my workspace I created an organizer that holds all the honeycombs.&nbsp;Also note that there are two types of trays. There are two types of trays: 3 mm and 5 mm, so choose the one that suits you best.&nbsp;I also intentionally created the skirt so that you can hold the tray with your fingers when stirring.&nbsp;<img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000427218/design/2024-04-13_3d287bca1f7fd.jpeg">

bole

holder

mélangeur colle