UndeadKernel

YelTrik Designs - Click FOLLOW

UPDATED AND IMPROVED VERSION!&nbsp;This is an updated and improved version of the P1 and X1 bracket that holds the Front Print Head Cover up and out of the way when replacing print heads. Think of it as an improved third hand! &nbsp;New Improvements <ul><li>Added a back-stop that helps keep the Print Head Cover secure</li><li>Lengthened the front-stop to better contain the Print Head Cover</li><li>Wider to increase stability</li><li>Reduced filament requirement by adding some stylish hex-shape openings. </li></ul>&nbsp;Design Principles&nbsp;The PRIMARY design principles for this model is ‘do no harm’ to the carbon fiber rods. I could have easily made this to snap on the carbon fiber rods. However, doing so risks damaging the rods (read: expensive and difficult fix). To avoid any damage, I designed straight faces where this contacts the rods. They provide the least amount of contact with the rod while still providing the required support.

"Hold It" V2 Print Cover Holder

X1 Mods

MingGY

便携的13路五子棋/围棋&nbsp;棋子有三个面，通过翻转棋子切换不同状态This is a set of flip Go. Each piece has three sides, and the state of the piece can be changed by flipping it.&nbsp;在测试中我遇到的一个麻烦是：黑白两个面体积更大，所以重量也大，在切换到黑白面时，由于轴两侧重量的不均，容易发生倾斜。因此保持棋子三个面在任意方向时，中轴两边重量的均衡尤为重要，我的解决办法是，在切片设置里，增加了没有棋子的一面的重量，减少了黑白子两面的壁数和填充，经过多次测试，目前达到了一个比较均衡的效果，各位直接下载配置文件打印即可，非常不建议各位导出我的模型到STL，然后自行切片去打印，否则你也可能会遇到棋子重力不均的麻烦，除非你能耐心多做几次测试。&nbsp;由于存在大量活动结构，推荐使用好耗材<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000489491/design/2024-06-09_5eb8aa722cb7d.jpg"></figure>

X1 Mods

Games