Travis

NordicWalker

I have made a simple case for my deburring tool that fits with the gridfinity system. I designed this so that it only uses the standard 6x2 magnets. the magnets are not the strongest but they hold on tight enough. The magnets need to be glued. some specs. <ul><li>case size: 2x4x4U ( 83.5 x 167.5 x 28 mm)</li><li>inner tool hole size:  25 x 157.5 x 21 mm</li><li>magnet holes are 6.5 x 2.3 mm</li><li>17 magnets total ( bin + lid )</li><li>holds 9 reserve tools (probably more but did not tested magnet strength with this)</li><li>printed at 0.2 mm but you can choose for yours</li><li>no supports needed</li></ul>&nbsp;Don't mind the holes in the lid on the pictures. I glued the magnets wrong the first time. So don't make the same mistakes as me, make sure the polarity of the magnets are right.

Gridfinity 2x4x4U Deburring Tool Case ( only 6x2 magnets )

gridfinity

晓翼工坊

可以配合磁力干燥箱使用&nbsp;Can be used in conjunction with a Magnetic drying box

铁氟龙管帽 PTFE Tube Cap

May print again

K2_Kevin

Bambu Lab AMS HUB Tool. Smaller diameter to fit the smaller holes of the AMS HUB.&nbsp;My full Bambu Tool Set can be found here:&nbsp;<a target="_blank" href="https://makerworld.com/en/models/14462#profileId-21419" rel="nofollow noopener">https://makerworld.com/en/models/14462#profileId-21419</a>

gridfinity

May print again

good