simple design and works well.

hung ours on the wall to gwt it out of the way. snug fit but thats honestly what I wanted.

cat loves it

fits perfectly. great finisher peice.

blew this up took 2 plates to make it and cut it in half and glued it onto somthing for the wife.

printed fine. just wasnt what I needed. just printed it to see if i could make a version that would work

works great.

I cut it in half and added attachments. turned out great. wife loved it.

Decided to use some silk i had sitting in a spool laughing at me. turned out cool though. and I have a place to put my plates when not in use. printed with no problem. I put 6 holes in the bottom of it for rubber feet though. a1 likes to rearrange the table if I dont.

printed 3 so we can fit a case in the cupboard thank you

made this dude smaller and cloned him 4 times. be careful pulling the supports off otherwise he'll have California compliant magazines. other than that they came out great.

came out perfect.

printed in esun pla and then also in polymaker silk. even on the smooth plate it came out perfect each time. literally started the print and walked away. make sure your build plate is clean and you should be good.