TimPrints

LoboCNC

Updated 2/8/2023: Modified the key to make it sturdier.&nbsp;IMPORTANT: After printing, first close the handcuffs to break free the internal latch. Trying to break the latch free using the key may break the key.&nbsp;These print-in-place locking handcuffs also print without supports. I put in a comfortable number chain links to make them suitable for casual wear. That is, you could wear them at a party and still, say, eat and drink. And most importantly, you can comfortably reach to put in the key to unlock yourself. And if you do lose your key, don't panic. The 3rd photo shows the internal latching mechanism. You can easily poke the end of a paperclip or small Allen wrench into the keyhole at an angle and push the latch open.&nbsp;I strongly suggest printing these in PLA with 0.2mm layers (to make the p-i-p gaps work out properly). The print profile provided includes mouse-ear brims on the links to keep them stable while printing. Break these off after printing. (I used to have a print profile without the mouse-ear brims for printer setups with excellent bed adhesion, but too many people were using it - despite the warnings - and complaining that the links failed.)&nbsp;After printing, you'll notice that across the round hole on one side, there is a single layer of wispy filament covering the hole. Use a small round tool or needle file to clear this gunk away. You can also use the pointy end of the key to clear this out.&nbsp;Lastly, when using the key, it only takes a small amount of torque to open the lock. Do not force the key or you will snap it off in the lock and then you will be in real trouble!

Toy Handcuffs with Key (print-in-place)

Jake

MKCAMC

I designed this modular spice rack to be stacked as high as you need it. Then a lid is placed on to to allow you to place items on top of the rack. It can be kept on the counter of in the cabinet. All of the pieces interlock well and there is no need for glue. Each section has slots for 4 bottles and a slot for small bags of spices. No supports are required for this print. I tried to make it as efficient as possible to reduce the amount of filament it takes to print each section. It only uses 177g of filament per section. Each slot is 52mm in diameter. If you would like to scale it for larger jars, you can use that as a point of reference.

Modular Spice Rack

Organizaion

MrGnarly

Remix includes updated model fixes for easier printing and consistency.&nbsp;All credit goes to the author below&nbsp;<a target="_blank" href="https://www.thingiverse.com/thing:2827196" rel="nofollow noopener">Toad from Mario games - Multi-color by bpitanga - Thingiverse</a>&nbsp;

Toad from Super Mario

Mario

LTS.Design

Table too short? This adapter allows you to reposition the air hose of the xTool S1 for a smaller footprint!The airflow is still plenty powerful.<ul><li>NO supports needed</li><li>NO additional hardware, M3 screws are included in the S1 accessories.</li><li>perfect fit</li></ul>The screws just thread into the plastic, don&#39;t over-tighten them!