Printed great from the phone, first try! (Black: Basic PLA, Top: PLA Silk, both Bambu). Seam is obvious/ugly, looks like a scratch/crack. The locking/opening buttons make it not great for stacking. And the top is a *little* low (or I made my deviled eggs too tall. Great model, best I could find on MakerLab and ended up printing two. Thanks to the creator!

Not bad overall. It was hard to tell where the under carriage of the jeep started (no pictures of the underside, that I saw), so I didn't know if it was to be flat or look like an engine. Without the special tool (not provided) mentioned in the assembly instructions, the "axles" that hold on the wheels were too rigid (in PLA) for the center hole in the wheel... I ended up breaking two axles before giving up. In general, the instructions could be more clear... maybe a stop motion gif showing each part coming together in order, or an Ikea inspired picture showing how the parts come together. I wasn't sure what to do with the small discs that printed.

Works great, no extra magnets or anything needed. I was a little confused by the support in the middle while it was printing, but in the end they snapped out no problem. Good model, thanks!

I duplicated for the other screw as well. One print was too snug and the Z-axis stopped moving, threw an error and halted the print. Luckily it was still leveling the bed. I just threw that piece away. The other parts fits very snug but they've been great so far (5 prints so far)

3rd Gen 4Runner has a perfect fit. Print was perfect first try. I went with PLA because that's all I have at the moment, but I'll reprint when this one breaks/wraps. Great model, thanks!