ThePrintsGioUniverse

Amazing_62

I want to design a bone pen holder This bone is flat on one side and round on the other. Form a circle and become a pen holder The gap in the middle allows light to pass through You can see the pen through the gap Print without support, print easily The bottom is wider than the top, so it won’t fall over even if you put a lot of pens on it.

Bone plank pen holder

nego

NinoGiannino

M8 spacer 5mm

Mono

SugarPaws3D

Adorable little dragons, easy print, no supports, tested down to 60% size <a target="_blank" href="https://www.patreon.com/posts/baby-dragons-103914440" rel="nofollow noopener">🐉</a>&nbsp;Features: moving head, body and tail ✿&nbsp;I created them to practice new textures but ended up liking the end result &amp; thought others would enjoy them as well!

Flexi Baby Dragon - Articulated Fidget 

Isabella

PrintFarm24

HOME WANDBILDFüllung wurde mit Moos eingeklebt → ich habe Islandmoos ( laubgrün / 200g ) von Amazon verwendet.&nbsp;HOME MURALThe filling was glued with moss → I used Iceland moss (leaf green / 200g) from Amazon.&nbsp;&nbsp;&nbsp;

HOME DECORATION WANDBILD MURAL

casa

Pulsar Designs

Disk Brake Rotor Tool for correcting a slightly bent or misaligned disk brake. I recommend printing with a tough and hard material so that the tool does not yield when using it to correct a disk brake.

Disk Brake Rotor Tool

Diggle

Small little soldering finder tool designed onto a gridfinity 1x1 plate. Hold onto those wires with ease!

Soldering Fingers (Gridfinity)

tools

thedecember87

stand to be able to place 3 spools inside the Bambulab x1c in filament drying mode, as can be seen from the images this stand was created to be able to house any type of spool inside it and thanks to its feet it allows excellent stability, very useful for those who also use the petg, asa, abs and similarThis stand was created to solve the problem of turning the spools every few hours to make the drying uniform. By doing so, by standing them up, the drying of the filaments is homogeneous and you can dry up to 3 spools at a time.

x1c dry filament mode multiple spool stand

Studio 727

<h3>UPDATED DESIGN! FITS ALL SIZE PLATES!</h3><h3>USE MY DESIGNER PROFILE FOR THE MOST CURRENT REVISION!</h3>Yet another plate caddy..This is my 5-slot plate holder featuring offset slots for easy identification, and a large base with 45° storage makes it very stable.Pictured in Bambu PLA Matte Ash Gray. See my A1 Mini Plate Caddy <a target="_blank" href="https://makerworld.com/en/models/83653#profileId-89351" rel="nofollow noopener">here</a>!<h3>Enjoy, and please boost 🚀 &amp; rate! ⭐⭐⭐⭐⭐</h3><h2>Thank You! 🙂</h2>

nego

Mono

Isabella

casa

MTB

tools

AmS

Accessori