TheClone

grecdel

Hi everyone&nbsp;This is my first contribution to makerworld.A Spiderman's portrait worked on HueForge.&nbsp;<ul><li>Bambu Lab Black to layer #5</li><li>Bambu Lab Red to layer #12</li><li>Bambu Lab Blue to layer #18</li><li>Bambu Lab White to layer #24</li></ul>&nbsp;Enjoy!

Spider man (HueForge)

HueForge

blecheimer

The Sunlu S2 is a really good filament dryer. But it has a major design flaw: The hot air cannot vent out. There is simply no large enough opening in the top cover. Ok, I could just drill a hole in the cover but I like printing more than drilling… So I made a gap spacer to keep the top cover a little bit open. This works suprisingly good and the humidity sinks under 20% during heating. The spacer sits flush on the bottom half and the cover just sildes in.&nbsp;Print the spacer upright with PETG. PLA might get soft if the dryer is set to high temps. As it is a functional part use draft settings. No time to worry about the looks. 3 walls, 4 tops & bottoms, 10% gyroid infill and no support - see my 3mf file (Bambu Studio / Orca Slicer) for more details and my PETG settings.&nbsp;&nbsp;Disclaimer: This work by blecheimer is licensed under <a target="_blank" href="http://creativecommons.org/licenses/by-nc-sa/4.0/?ref=chooser-v1" rel="nofollow noopener">CC BY-NC-SA 4.0</a> You are not allowed to copy this model to other 3D printing websites without my permission.

HueForge

To Print