Been working great!

Printed in ABS. No issues what so ever. Great print.

Printed in PLA Tough+ black and then added some flair. Holding the laterens very well!

Too awhile but finally got it all together. Sliced the top part off of the main section to reduce the amount of supports and cut some time.

Leaked something fierce out of everywhere, but it moved several gallons of water from a catch pan under the washer to a bucket. TPU gasket should be a little thicker.

Printed one so far with PETG HF and it works amazing in the AMS. Will be printing more.

Perfect fit!

Been working well with PLA tough+. good print quality. some of the infill was a bear to remove and I didint need it in the small opening towards the back.

part wasn't designed for dehydrator but I made it taller and it worked out pretty well.

Printed well. I did end up gluing it together because it was a little flimsy. Will be printing more! Thanks

Amazing design! I did make the remix for directly mounting to a wall or shelf. I'm printing one for every color we are going to keep on hand. All 30 of them.

my daughter got a tomato plant from school we put in there for now. it printed great with the left over filiment sent with the printer.

I really like the simplicity behind this. I have no idea what brand the roll is from but I measured it and the 195mm fit fine.

I preset Watermelon Disposable Service's. I really like this design! The wheel setup is amazing. The green is left over from the original roll Bambu sends. My only complaint is the top pieces do not have an indent or anything to guide where they go and my OCD would not allow them to be off center. I know it would be a nightmare trying to make an indent and ruin the amazing looking top with the PEI plate. I might print another lid on smooth starry plate.

Printed beautiful! I need a cone cutout for the horn mug. Thank you

Printed great with recommended settings. nice job!

printed great!