Tanzelini

ALL M3 Bolt Remix - 4in1 PTFE mount Side Spool

All M3 Bolt Remix – 4-in-1 PTFE Side Mount Spool Holder

1/2" PVC Pipe Connectors for RaceGOW / Tiny Whoops

Compact Pinecil Case

G4ZO

5 inch fpv prop box

0.2mm layer, 2 walls, 15% infill

Definitely like the snugger and more solid design compared to the original.
Might make a remix where the center slot is rotated 45 degrees to maintain symmetry since I think the width towards the center should allow it

DevonR

FilmPod 35mm film holder with dividers

PLA | 0.2mm layer | 2 walls | 25% infill

Printed the smaller "lower half circle" one and it fits great

吾等斩去红尘时

摇杆保护套 RadioMaster Pocket

RadioMaster Pocket Joystick Protector

RadioMasterPocketAllInOne

Super useful print. An improvement could be an option for a printable tpu bottom that could somehow be attached to keep it from sliding as much

gadjet

Simple Soldering Iron Stand with Solder Holder

0.2mm layer, 3 walls, 15% infill

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian

Earn this badge when print successful more than 100 different models and 500 hours

Pioneer Maker