I love this. Daughter loves it, included storage in the idea, it's so simple which is why it gets 5 stars for the perfect distraction! I personally would of and did make a few design changes: 1. The dirt wants to pop out even with a single flower in the center hole. I figured a small simple twist lock hidden in the dirt edges would be awesome. I'm not sure I'm talented enough to do this. But you did mention it just sat in there, so no star points off. If its set up carefully it doesn't fall out. 2. Personally the middle of the flower segments were too hard to add the petals too, so I printed them 5% bigger and its almost perfect with only one spot where a petal doesn't want to stick so I'll print my next at 4% and such until its right for me and my daughter. Again, with a well dialed in machine and not a young motor skill challenged daughter this may not be a problem for most people so no stars off.

works great

Its hard to beat something so basic. I've tried a lot of the new fancier rolling ones and I just don't like them. This with the little clip, just works perfect for me.

Is exactly what it says it is. I used it to see if I was missing anything on an otherwise clean surface but I totally could see needing this for a hard clean up.

Works perfect.

You'll get great results if you calibrate your filament and printer, this was done without any calibration and still came out pretty nice even being half matte and half shiny because I can't read! I used M3 x 10 mm Screws with M3x5.7x4.6 Threaded inserts, but I do think you can get away with M3 x 6 mm and M3x4x5 inserts. Now, saying that, here is the sets I got to figure that out for you. Inserts- https://a.co/d/2KjxX4p Screws- https://a.co/d/dg1hhfs The light I bought, Idk if Its best, but it works. - https://a.co/d/0uaN1hW Mind you there has been people saying you should glue or otherwise secure any light you get and not rely on the sticky. It really only fits together one way. I did learn at the last minute that the raw stl files contain the bottom front piece for P1S, so there's that. Otherwise...really was a well made and simple project that adds a lot of storage space and a way for me to open the top without my daughter or cats jumping inside.

Printed and fit just fine in my p1s. Thx