Easy print, works perfectly

Fun little print in place fidget.

This fidget spinner is so much fun. Its smooth and spins very well for not having any bearings in it. Easy print.

These were a fun gift for my Father-In-Law. Printed a few of them and tossed in a gift card with a note telling him it was for more filament. He loved them. They are a bit difficult to snap together, I had to use a rubber mallet, but, they will stay together for sure!

Increased the size of the model from 70% to 135% and changed it to 3 walls and 10% infill since I was gifting it to a toddler. Came out perfect and strong. Coke can in pic for scale.

Great model. Was easy and fast to print and works with my Outemu Blue Keyboard Switches perfectly. I did upload a new profile for both the AMS and Non AMS version that should work with all printers to make it easier for others on other prints to print.

these work perfectly for my Bambu spools. nothing leaks out. Because of the grid they take a long time to print, especially when doing multiple. well worth it.

The holes could be just slightly bigger, however, I was able to use the file to expand the hole just enough to fit.

Amazing dock for this tool. Love how it holds all the pieces. Print was smooth and easy.

Perfect sizing and works well. I wanted something compact but that could still hold all 6 pliers. There is room for one more.

had to open in Bambu Studio and move the key around for the P2S to print. not sure yet how to add a print profile for the P2S but making that small changed printed fine. the key is a bit too tight so need to scale it down slightly. other wise a great print!

great plate holder. it does slide around so may need to add some rubber feet to it.

fun little fidget toy. they glide perfectly and do not catch.

great print. was easy to assemble and attaches to the board easily.

perfect and sturdy holder. easy to print.

I love you can mix and match colors on this model. Went with black and great for the outer box and grey and blue for the tray. this box is strong and the latches work great. holds everything perfectly.

Great print. holds the tool well. easy to slide the tool in and out. printed with Basic PLA and holds well.

great simple print that does not use up a lot of filaments.

these are good but just slightly too tight on the official Ilea Skadis board. They hold but you can’t pull them down at all. The extra bump makes it not fit well. going to try increasing the size just a tad on my next run.