Super_Guard

JamesThePrinter

This organizer is intended for your desk or 3D printer organizational needs. It features a mid-century feel with 6 separated storage areas. The included drawer should be used, but is not a requirement. The drawer handle requires 2 M3x12 bolts and is comprised of 3 pieces:<ul><li>Handle Support - Print 2x</li><li>Handle - Print 1x</li></ul>&nbsp;Print SettingsA brim may help with the handle pieces, but it is not necessary. No other special settings are needed.&nbsp;Drawer Assembly Instructions<ul><li>Insert both bolts through the holes in the drawer. </li><li>Slide the Handle Supports over the bolts. The flat end should be against the drawer. </li><li>Carefully screw the bolts into the handle. DO NOT OVERTIGTHEN. Because the handle is so small, it will crack if you overtighten the bolts. This is especially true if you use a silk filament. </li><li>Be sure to orient the curved end of the Handle Support correctly so that it pairs with the profile of the Handle.</li></ul><figure class="image image_resized" style="width:75%;"><img src="https://makerworld.bblmw.com/makerworld/draft/745895/2024-01-15_s740vq3lrdz5.png"></figure>&nbsp;&nbsp;<a href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow">Buy Me A Coffee</a>&nbsp;The following filaments were used in the pictures above:<ul><li>Bambu Lab Matte Desert Tan PLA</li><li>Bambu Lab Matte Lemon Yellow PLA</li></ul>

Mid-Century Organizer

Más tarde

lasse1999

Container for especially cotton swabs, when you are traveling or on the go. Can be used for much more. Remember to check out my matching container for cotton pads.

Más tarde

sd card