great print, the tip broke off at it's base after it got stuck out during an attempt to close it. not the prints fault but a heads up to be careful with it. we super glued it back together :-)

i designed some legs for it to. is that something I should publish here? I'm newer to this and would appreciate you feedback on that

i scaled up 158.75 in two dimensions because I wanted the drawer height 3" and the drawers a bit wider. left depth the same. An unintended consequence of this is that I didn't experience any tightness that others have described due to tolerances being 58.75% larger. i would say the tolerance is within ideal range but could be looser or a little tighter and still be good on my scaled print.

i made it out of petg, it feels very sturdy I love the little gecko and the design is nice. thank you for sharing!

This print straight up broke my hotend first go. I had read all the comments and In response made a crown of PETG support for PLA model thinking this would keep the print stable... well it did. the print held in place so well that when the hotend collided with the print and it completely bent the hotend. after a lot of research I think this is an issue with the adaptive cubic infill on larger models. I successfully switched to gyroid and reprinted Easy v. with a new hotend no petg supports.