SumTingWong

TomoDesigns

<h3>Introduction</h3>A simple and easy-to-print fidget toy! That looks like a little joystick. Perfect to test your printer or just as a fidget on your desk. It makes use of a spring gear that will bring back the knob that you are moving back to the center every time.&nbsp;Go up down left right. The perfect gamer fidget or just something for people to relax. I have updated the bottom piece for a easy print finish instead of the steep overhang.&nbsp;Every make will be featured on my Instagram add your handle and follow me :) Check out <a target="_blank" href="https://www.instagram.com/tomo_designs/" rel="nofollow noopener">my Instagram</a> if you want to see more designs like this or if you have questions!&nbsp;You are NOT ALLOWED TO SELL PRINTS of these or any of my models unless you have an active commercial license on my Patreon.Do you want to support me or become a reseller of my designs? Go take a look at my <a target="_blank" href="https://www.patreon.com/TomoDesigns" rel="nofollow noopener">Patreon</a>!&nbsp;Do you like the filament that I used? Here is the <a target="_blank" href="https://amzn.to/3ft9dSg" rel="nofollow noopener">Red</a> <a target="_blank" href="https://amzn.to/3SXACth" rel="nofollow noopener">White</a> and <a target="_blank" href="https://amzn.to/3FDHcCg" rel="nofollow noopener">Black</a> link!&nbsp;More of my designs:<figure class="media"><oembed url="https://www.youtube.com/watch?v=g-U49XYFXtE"></oembed></figure>

Joy Fidget

aim6mac

since i got the A1 mini I wanted to make the footprint of it smaller , now I finally had some time to do it enjoy…&nbsp;recommendations on the spool installation when not using 4 filaments at the same time on the AMS lite3 filaments : 2 in front 1 in back2 filaments : 1 front left , 1 back right or 1 front right , 1 back left1 filament : 1 front left or 1 front right&nbsp;The pins to connect the left feet and the top bar are tight and only go in one way correctly, if the holes do not line up turn them 180° until they do line up, otherwise this will end up with crooked left and/or top bar!&nbsp;8 x M5 x 25mm bolts needed to assemble the whole unit. <figure class="media"><div data-oembed-url="https://www.youtube.com/watch?v=otxYWoVrrcM"><div style="position: relative; padding-bottom: 100%; height: 0; padding-bottom: 56.2493%;"><iframe src="https://www.youtube.com/embed/otxYWoVrrcM" style="position: absolute; width: 100%; height: 100%; top: 0; left: 0;" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen=""></iframe></div></div></figure>

Toy

Tools