SubieOwner

planes01

<h3>Overview</h3>A-10 Kit Card upgraded to 3D fuselage format&nbsp;Check out the <a target="_blank" href="https://makerworld.com/en/models/199176" rel="nofollow noopener">SR-71</a>, <a target="_blank" href="https://makerworld.com/en/models/242106" rel="nofollow noopener">B-52</a>, <a target="_blank" href="https://makerworld.com/en/models/436445" rel="nofollow noopener">A-10</a>, <a target="_blank" href="https://makerworld.com/en/models/402126" rel="nofollow noopener">787</a>, and <a target="_blank" href="https://makerworld.com/en/models/405459" rel="nofollow noopener">Darkstar</a>!Check out the full airplane kit card collection → <a target="_blank" href="https://makerworld.com/@planes01/collections/991821" rel="nofollow noopener">linked here</a>!<h3>Profiles</h3><ul><li>Kit With Frame<ul><li>plane in a kit card format ideal for gifting to others</li></ul></li><li>Kit No Frame<ul><li>plane without a kit frame ideal for assembly right off the printer</li></ul></li></ul><h3>Filament</h3>As shown:<ul><li>eSun PLA+ Gray</li><li>Hatchbox PLA Gray</li><li>Bambu Lab PLA Black</li></ul><h3>Tips</h3><ul><li>Model requires close tolerances to ensure snug but not tight or loose fit<ul><li>Make sure the model cools to room temperature before assembly</li><li>Ensure filament is properly calibrated with no excessive over extrusion</li><li>If there is some over extrusion the parts may need to be lightly sanded at interfaces for fitment </li></ul></li><li>Ensure good bed adhesion<ul><li>Make sure printer is fully calibrated</li><li>Make sure print bed is clean &amp; dry (soapy water is my favorite for cleaning - simple &amp; works)</li><li>Make sure filament is dry (wet filament can generate non-continuous flow that can cause bed adhesion issues)</li><li>Cooling &amp; Temps - make sure they are correct for your printer, build plate, and filament</li><li>Smooth PEI plate is recommended</li></ul></li></ul><h3>Assembly</h3><ul><li>Remove all pieces from the kit</li><li>Debur as needed to smooth edges</li><li>Insert wing into forward fuselage slot</li><li>Insert horizontal tail into aft fuselage slot</li><li>Insert engine pylon into fuselage</li><li>Insert engine into engine pylon</li><li>Insert missiles into wing</li><li>Place airplane onto stand</li><li>Enjoy!</li></ul>&nbsp;Snap into place design<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000436445/design/2024-04-27_32e8c49417456.gif"></figure>&nbsp;&nbsp;&nbsp;

stuff to print later :)