I asked the creator for a profile without the ears and it came out great! Supports were easy to remove and the surface is pretty smooth. Assembly was pretty easy as well. I tried a few different options for the yellow. I also did a scaled down version to roughly match the size of the Pokeball Plus from the Let's Go games. I'll include the colors and scaling I used in a comment. I'd like to see a version with a rounded bottom for cosplay purposes but otherwise this model is perfect.

Great print, simple and effective. I play my switch hooked up to my PC monitor and wanted something that was out of the way but accessible if I needed to un-dock my switch and this does the job. Bonus points that it doesn't interfere with the HORI ergonomic joycons. Printed well with no issues. As others have noted, doesn't fit the OLED dock. I'm hoping to see a similar design for the Switch 2 dock when that is released.

Simple print that does what it's supposed to. Way more space efficient than the base plates provided with Nendoroids.

Was looking for a simple solution for keeping a six pack in my office and this solved it. I'm in the US so I had to adjust the width (Z in slicer) of the ramp and shell pieces to accommodate 12oz (355ml) cans. I increased the Z measurement to 132mm and it works like a charm. I'd recommend doing an outer brim on the side pieces as I had some warping near the top front of the sides without one. Testing with a 1cm outer brim resolved the issue. Otherwise a great print.

I love it! Now I get to have my hunting buddy with me in my office :) Prints all came out great on my A1. The supports were generally easy to remove though some were more difficult than others. Assembly was a breeze, the tolerances were all perfect. If you are going with glue for assembly, a little goes a long way. I'd also recommend placing the smaller bits like the toe beans with needle nosed pliers if you have them.