Printed out nicely. I increased the size in Bambu studio to suit the folding steps I printed them for. The increase in size was pretty small so no real issues with the screw holes. Just got to find time to fasten them to the wall.

Printed nicely in Bambu PETG-HF. Thought it may have been a bit tough to open the clamp but pleasently surprised at the flexibility. Just have to wait for the next round of present wrapping to use them in earnest. Thanks for the design.

Printed fine, no issues with the ball while printing but it was rather difficult to seperate the ball when finshed. I douldn't do this by hand and had to basically chisel it off with a small electricians screwdriver and a small plastic faced mallet. This left the ball somewhat flat and didn't funtion as desugned. I reprinted using the pause profile and this was much better. I remixed the model shortening the height of the 'solid top' and added a hook so i could mount to the top of the shoer cubicle glass wall. Works pretty well now

Nice & easy to print using Bambu PETG-HF. I had to reprint the sliding cover 2 more times as I kept closing it too far and when turning the knob to lock it, the end of the knob pushed up on the edge of the lid and broke it. I'm more carefull closing the lid now and may at some point file down the part the collides. Very impressed with the design and the initial idea for this model.

Printed fine and fits perfextly. Not had a chance to test it out as I cannot fimd my power lead for the sunlu connector.

Printed easily and fits well