Does make it easier to swap hotends. I only used the 0.2mm nozzle as it was the one installed. Printed in Overture PLA Silk Copper.

Excellent model of an iconic jet. The stand is a little loose in the plane, Printed with a 0.4mm nozzle with 0.12mm layers using the following filaments: Bambu Lab matte Charcoal Bambu Lab matte Ivory Bambu Lab matte Ash Grey Bambu Lab basic Sunflower Yellow Bambu Lab Silk+ Titan Grey

Perfect fit. Test print in Matte Charcoal. Going to print again in ASA soon.

So far, this is the best YF-23 model I have found. Printed it at 172% (13.5" long). One of the ruddervators were on the wrong face and had trouble printing. Plane was printed in matte Charcoal for the body with dark Grey trimings. The cockpit in Titan Grey. I really like the model, the leading/trailing edge of the wings and ruddervators were a little disappointing (very block shaped).

Another great model. I am looking forward to your next release. The details are incredible. i may print this again with darker colors. H2C, 0.4mm nozzle, 0.20mm layers. Filament used: Bambu Lab matte Ivory White Bambu Lab matte Nardo Grey Bambu Lab basic Dark Grey Bambu Lab basic Bambu Green Overture Silk Copper

Excellent model. I did not have any trouble with the inlaid trim pieces, just need to make sure that the channels are clear prior to installation. It's quite the model, with a 27.5" wingspan. I need to print this again with even darker trim pieces.

Great model of a historic warbird from WWII. I printed the 1:35 scale version with Invasion stripes. I used Army green instead of black.

I printed 100 to a plate. truly the best filament clip for Bambu Lab spools.

Excellent model. The details are great. I also had issues with landing gear axles were too small, holes for the axles were too small. I just scaled up the axles and added a negative cylinder to allow the axles to fit. Printed in Bambu Lab matte Ivory White, Bambu Lab matte Charcoal, and Bambu Lab Silk+ Titan Grey. 0.2mm nozzle, 0.08mm layer height. I combined the two wing pieces into one.

significantly quieter. Thank you for the magnetic filament cutter stopper upgrade. Printed in Polymaker ASA black on my P1S. 0.2mm nozzle with 0.08mm layers.

Another spectacular model! I have printed all the Masterbuilds now. I am looking forward to the next release.

Absolutely fantastic model. I did have a small gap between the mid section and rear section, which i will fill with plastic putty. The press-in letters and roundels needed resizing.

Excellent model to go with my A-10 collection.

Great model. Printed in matte black, matte red, and silk titan grey.

I broke my original one, my replacement should last a long time.

Excellent addition to PB94's SR-71 SNAPKIT model. The only thing that would make this better is if it had the actual tail number (17972).

Wonderful mother's day gift.

Another spectacular model. The details really reflect what a beautiful and unique aircraft this is. I appreciate your attention to detail.

Another spectacular model. The pivot pins for the rudders seemed a little fragile, so I merged the two pieces of each rudder into one piece. I am looking forward to what is next.

Really enjoying the Command and Conquer models. Keep them coming.