Staylevel

Think3D

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Start with Black At layer #13 (1.12mm) swap to Jade White At layer #21 (1.76mm) swap to Red for the rest.&nbsp;___________________________________________________________________________________If you like my work, please consider a small donation :) Thank you very much :*<a target="_blank" href="https://www.paypal.com/donate/?hosted_button_id=RWRXKCAEM86K8" rel="nofollow noopener">https://www.paypal.com/donate/?hosted_button_id=RWRXKCAEM86K8</a>&nbsp;

Pokeball - HueForge

artwork

Jaxel

I get a lot of schmutz and dropped strands of filament in the base of my X1C chamber. Cleaning it can be a bit cumbersome. I didn't like any of the chamber ramps here on MakerWorld, they had curved ramps, which increase the grade towards the lip, and required supports to print, not to mention strands would get caught on layer lines.&nbsp;So I made my own. It is not curved, so the grade on the ramp stays constant. It is also easy to print, without needing any supports. Print it face down, on a smooth surface, such as the engineering or hot plates; and there will be no layer lines. The designer profile has a variable layer height.&nbsp;Print in a heat resistant material like ABS or PETG. I also used double-sided woodworking tape to keep it in place.&nbsp;You can find other models I have released for the X1C/AMS here:<a target="_blank" href="https://makerworld.com/en/u/2811301167/collections/109412" rel="nofollow noopener">https://makerworld.com/en/u/2811301167/collections/109412</a>&nbsp;If you appreciate my models, please consider <a target="_blank" href="https://ko-fi.com/ultrajaxel" rel="nofollow noopener">buying me a coffee</a>!

artwork

Prints