星骸造物-StarK

luckyluc.64

The best PTFE guide plus PTFE Release (no tools require).There it is. Many Makers asked me for this after seeing the one I designed for the AMS Hub.<a target="_blank" href="https://makerworld.com/en/models/73523#profileId-77971" rel="nofollow noopener">https://makerworld.com/en/models/73523#profileId-77971</a>Since the location is good, I didn&#39;t add a subplate and relocate the buffer. The drawback is that I only have a little wire management.&nbsp;In a certain way, it&#39;s better because there are no holes to tap or screws. It just &#34;Smap in place&#34;.It&#39;s also easy to assemble;-Release the two PTFEs from the buffer.-Snap the central part on top of the AMS Buffer. (See the pictures above) (injector end first and snap the other end)-Slide in the two PTFE guides and secure them with the &#34;C&#34; ring. (The longer one goes in the Injector side)-Push in the two PTFEs. Tug them back to see if they lock in place.It&#39;s ready to go. Thanks to the realignment of the PTFE in the fittings, you won&#39;t need other tools and will avoid jams.It&#39;s not a bad idea to chamfer the inside of the PTFE after cutting it.&nbsp;After printing, make sure the holes are clean. The guide should slide easily and freely into their mount. It may require a little filling in the bores.&nbsp;I did test it with PLA. And the small tube broke. Then, No, you can&#39;t use PLA.I test-printed it with PETg, which prints well for the P1P one. It works well, and no support is needed (But it can&#39;t hurt). I didn&#39;t have to file or sand the bore, but it may be required (Especially if you use generic material and print on a series P1; the flow is critical). The injector side guide must slide freely, and the PTFE should slide into the guide freely. It doesn&#39;t matter if the PTFE slides into the guide or the guide slides with the PTFE.Of course, I did make it in ABS. It&#39;s the best for me and my favorite BBL Blue ABS.&nbsp;It prints in an hour and a half in PETg and is even faster with ABS.Enjoy.

打印机配件