printed great with no issues I wish there was a spacer template that was just an outline of the bottoms since the face of my cabinets were taller I just made my own but my design (which to be fair is my fault) caused it to bow so they're a little tight of pulling out.

perfect solution for my plates and bowls

fit my p2s perfectly and solved every feeding issue I've had. did have it break once when doing a full size bed print but outside of that niche scenario it's great and I just printed another and went on printing again.

these were the best solution I've found since they used actual bearings for the holder. I printed for 4 for my bmcu setup. they can get slightly wobbly but I connected mine with tape so with 4 rolls of filament and the base be 4x wide they work great!

printed every size for my girlfriend and even made a holder so she can store em better for her needs.

This prints very well and the supports remove easily. It maybe user error but sometimes the top connection piece just doesn't want to slot in outside of that my only issue was not considering the height of the front of my cabinet so I had to print and glue on some shims so they could pull straight out. This is a very handy print I'm not finished yet but getting there!

printed extremely well, supports removed easily with no problems