SorenTheSwede

All my MultiBuild Remixes and Designs in one convenient locations

MultiBoard/MultiBuild

Ratcheting Clamp Desk Stand

Hobby Ratcheting Bar Clamp Adjustable Jaws

Spuhr SICS Cheek Piece Spacer

Stir Cup Lid

Paint Stir/Mixing Fork

MultiBuild Plate Side Hook

9 mm Small Thread - Flat Head Magnet Cut - Bolt

Master Tools Bender Blade Holder

MultiBuild Paint Tube Holder v2

Minimalistic Multiboard Tamiya Bottle Holder

Multiboard/MultiBuild 4-Snip Holder Gen2

Minimalistic Multiboard Citadel Bottle Holder

Multiboard 1-Piece 10-Degree Angled Foot

Multiboard 10-Degree Angled Foot Extended Toe

Multiboard 10-Degree Angled Foot

Multiboard AK Interactive Single Bottle Holder

Multiboard Mr. Paint Single Bottle Holder

Gridfinity 3x4 Caddy

Gridfinity 36mm Stackable Paint Caddy

Gridfinity 40mm Stackable Paint Caddy

WSlomo

Universal protective scalpel sheath

0.2mm layer, 2 walls, 15% infill

Had some issues with the corners lifting on my first attempt. Cleaned the build plate and slowed down the print and it looks much better. Had some small lifting on onw corner but it's not noticeable on the final print.
Printed in PLA with PETG-HF support interface.

suit1337

The Army Painter Wet Palette - Drybrush Insert

0.2mm layer, 2 walls, 10% infill

Added a little hanger (in retrospect I should've added it to one of the short sides and dried the PETG properly before printing). Easy print!

GravyRobber

Paint Brush Holder

Excellent design! Opted for applying fuzzy skin (0.2, 0.3) to the exterior of the handle and the lid. Had to trim the indexing tabs a wee bit with an Excto knife for the jaws to slide into the spiral plate correctly, but that might be down to my printer settings and filament choices (Sunlu PLA for the grip and lid and Bambu PETG HF for everything else).

Not sure if I'll be adding any weight to the handle; will try it without before I make up my mind.

Ashwood

Miniature painting handle: "The Chuck V2"

0.2mm layer, 2 walls, 13% infill

Earn this badge when print successful more than 100 different models and 500 hours

Pioneer Maker

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian

Solder Assist Tool Holder