had the printer occupied for the day lol but mom loves it. great print

perfect -- settles inside at 10% RH - thanks

Great! I have them rolling all over the place -- storage and AMS's Cardboard - they drop inside, small chance to lean but never came out during prints Plastic/Bambu - I have 1 in a Sunlu refil spool atm in my HT and its staying in fine

Printed just fine - had 3 copies on the plate to try to use every last bit of a roll lol nearly made it 20 layers shy.. but kinda like the outcome helps you see the split when its time to open .

Perfect - as well as the desiccant tower -- this was right after closing the lid room sits at 35% RH it dropped 10% before I could pic -- settled at 10%RH now i just need to find a nice way to store this box so its not just on the floor.

Just a heads up --- Just purchased SkAdis board today from IKEA - maybe they changed the size, mine measure 13.75 -- so first print of 14.2 floated a bit - minor scale adjustment to bring it from 7.1r to 6.875r. Perfect

print is great!

Fairly good print, 6 minor leans on 1 box. The verts wobbled a bit on me caused 6 of them to lean out. The print recovered and still sealed off so it holds ok. Since it was maybe 85% done i let it ride. Thanks! Looks good in box. Printed in PLA Silk well knowing if I run this dryer for anything else ill just pull this out during that dry.

sick!

nearly perfect for the tool box!

Print looks great, need some hardware to get it installed.