Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 376 different models
Pioneer Maker
Print successful 380 different models and 2,920 hours
The post is no longer available
Share
0
0
0
Share
0
0
0
I really like this design, but it has a major drawback: after breaking in (I opened and closed the box for 1 minute, about 20-30 times) it it so loopse that it opens when it is outside down. Which means that if you have it in a pocket or bag, the medicine may fall out. This is for an older woman with strength issues in het hands, so I cannot print a version that is very hard to open, unfortunately.
Share
0
0
0
Share
0
0
0
First I printed the original profile in Bambu PLA Basic, but like others, the center pole broke. Then I printed the profile with extra tolerance in both PLA Basic and PETG, which both work fine.
Share
0
0
0
First I printed the original profile in Bambu PLA Basic, but like others, the center pole broke. Then I printed the profile with extra tolerance in both PLA Basic and PETG, which both work fine.
Share
0
0
0
Very nice, but just a bit too tight. It broke off the piece where it should rotate around. I printed in ASA.
Share
0
0
0
Share
0
0
0
Share
1
0
0
Fantastic!
One minor thing: I printed the cauldron from the new version, but in the new version you have "Divider-3" twice, and Divider-1 is missing (I used this 'old' version to print it).
Share
0
0
0
Fantastic. I had to find the instructions for removing the LCD screen on my O1S, but that wasn't too hard.
Share
0
0
0
Share
0
0
0
Share
0
0
0
Printed in Bambu PETG HF in 100% and 200% size. I added a brim as a safety net. Turned out good.
Share
0
0
0
It printed good, although I had stringing issues with the hat. Not sure if that was my fault, so still 5 stars. A bit more space on too of the candle would be nice for easier access to the bottom on/off switch would be nice, but that is a minor detail and would change the model design.
Share
0
0
0
Thank you, perfect for my scheurkalender!
Edit 29 May 2026: After almost 5 months, suddenly one of the 'legs' (the long pins that go through the holes of the calendar) broke off. Because of the vertical print orientation of the legs, they break relatively easily along the layer lines. I printed the calendar again, but with the legs horizontally for added strength (supports are needed, but are removed easily).
Share
0
0
0