This is an amazing little shovel, the 3 year old I gifted it to loves it! It's been thrown on the floor a few times and the integrity of the print is great still. I think it was a M3 screw we ended up using? Pretty tiny. M4 was definitely too big, if that helps anyone else who prints!

Printed this out as a birthday gift and it was great! If you don't want messy overhangs, I'd recommend printing with supports. I wasn't too worried about this so I didn't use any.

Definitely print in PLA for better adhesion, or be prepared to mess with it a bit. Mine works great! Finally my mat doesn't launch off the side of the stand, and the 24" mat works with it.

Works great!! It's a snug fit but not difficult to put on, and works exactly as it should.

Works exactly as it should. I love that it holds so much and feels sturdy, and now my table is clear!

I love the fact that this spooky dog gets to travel with me as a keychain! Good range of motion on the fidget, and the tail swish is so cute. No issues printing in matte PLA!

So excited to have this on my bag! Very sturdy print and fits well on the keychain findings. The stringing is an error on my part not adjusting for my fussy filament choice. It printed just fine on my A1 mini with a smooth hot plate.

Small fidget, with great articulation! I had no issues even with such small details, and it's thin but sturdy to use. Printed in matte pla pink, on an A1 Mini. No adjustments were made to the print profile.

I printed this in one color and then used Shutterart acrylic markers to add details. The print itself was good! I found that without supports, the back of the keyring tail sags and doesn't have a great finish. The recipient didn't mind though. Printed in Elagoo Matte PLA pink, and added Ironing to the top of the model for a smooth finish.

Finally a great way to store my by the yard zippers. I can comfortably fit about 3 yards of zipper on it and store over 23 pull tabs. I love the fact that my zipper pulls are in the same place as the tape. I would love to see an even wider-sided spool for more zipper storage! I printed in black Overture PETG on a smooth holographic plate, and changed the first layer to octagram spiral. Fits on an A1 Mini in two plates!

I love this model! I was able to get about 3 yards of zipper on it and store over 23 pull tabs. Compared to the original, the honeycomb saved on filament and I didn't find any issues from printing it. I printed in black Overture PETG on a smooth holographic plate, and changed the first layer to octagram spiral. Fits on an A1 Mini in two plates!