After some initial failures was able to print with Holographic face. Thanks to another user for suggesting the coordinate tabs to adjust the x height. I adjusted to 1mm on my P1S and also added a hole in the middle to look more like a faux album. Print looks great and I do appreciate the work put into it.

Model printed excellent. I did have a support failure near the right horn, but had nothing to do with the print quality. Your getting a boost from me. Not sure if you can but would love this model or one extremely similar with the horns more raked back and less like a water buffalo rack. Thank you again.

printed great and is working great. Just have some patience assembling and maybe a thin strip of tape.

They came out great. Thank you.