Made a quick test. the design is almost solid. But the short sides should have stoppers too, now, in extreme cold climate, the dome can slide off (-30C). Also, had to scale to 105% to meet law minimum size requirements (also, here it have to be yellow).

Superb :)

Perfect.

Nice design. The tub is way too wide for modern narrow telephones without large casing. But that can be dealt with, even in Bambu studio maybe. Motorola One (2018) for comparsion. I bet a modern 8 inch tablet woud fit in it. The CD slot was too thick and wide for my Skoda Octavia MK2 so I made it 1mm thinner and 1mm narrower.

LOL it is super nice print. I did not read the description, and i don't have A1 Mini. But hey, it is awesome!

The holes were wrong size for my aplication so i filled it and made a negative cylinder object with correct size in it.

If the keyring hole was 3mm instead of ~2-2.5mm, it would be 5 stars, now the tight ring fit is more prone for breaking if in pocket because no play with standard rings, ring is now solid 90 degrees. But I hear some of the originals indeed comes with small hole, I wonder, if those are actually, originally fitted with a small closed horseshoe shaped wireloop of 1.5mm wire? Would make sense. I did that. My old Ford OEM keyfob had halfmoon shaped 4mm hole. I printed this Flat on texturred PEI plate. Saved 30min time and questionable amount of filament :) Good print.

quite loose fit. But works fine.

Superb.

Some support brackets for the top part would be good, it sags with time (PLA, PETG). 5mm Wider hole would be better, now most Mini glue guns (7mm rod) doesn't fit, but that can be mitigated with scaling up. But then all other dimensions grows needlessly. Good print.

would be nice if there was an option to print it in one piece.

Great item. Fits perfectly. Type of V8 battery tht i had was with 18650 cells. And is labeled: "Battery pack 6-cell(238168) INR19/66-1" And individual cells says: US18650UTC5D 5D G 1444932BF21A MURATA INR19/66 Note that this battery shell had six tabs that holds it. It had even Hotglue, and was really tight, but I heated the battery to 60c and it came out easy.

Great Model. Had some issues with the Plate 1, main body truss. adhesion issues, but when i flipped it upside down, no problems. I would recommend not to print the color parts with the cockpit. Use acrylic paint and save 6 hours and lots of filament. Engines and nozzles came out very good and minimal filament loss. I printed them without the Prime block. Super.

Great!

Great simple project.

I wish it was genuine gyroscope frame, but it isn't. Nice object.

Great idea. A bit large, but so is the carkey that is inside it, not at all too little room. Had to modify for fitting original plastic key handle. Added text in Bambu Studio, also repainted the sides to match a known German make.

Great print.

Good part.