Prints easy and looks great. However, if you're going to print with other material such as ABS remember to pull it out or else you may cause some problems. I forgot but got lucky that it just fell out and softened on the bed away from everything else.

Love the recommendation for dual colour! It looks great and it's not too difficult, perfect for kids!

Very useful and prints easy. I know the lines don't quite match up because of the filament size but I just compared it to a guitar that I already loved the setup on and matched the lines to that, it worked out great. If nothing else it'll let you know where the high frets are. Great print!

I reoriented these to make them all fit on the first plate. I also made it a 2 colour AMS print to make the raised writing stand out. These do the job very well!

This the perfect height for both electrics and acoustics. In just the last couple of days I've used it to setup and repair 27 guitars. At first glance I thought the vertical orientation would be precarious but it was very stable, didn't fall over at all.

Insert fit was a bit finicky. I changed the insert design to remove the tabs and just have tighter tolerances to where it inserts snuggly

Works perfectly, nice design.

Prints well and supports remove relatively well. Tolerances are good and it's a really fun solve.

Perfect for using up spare filament. A touch flimsy but it does the job with slow speed on the drill.

I was unsure how this would hold up. it's been months of use and it still works perfectly.

Tolerances and fuzzy skin addition makes this work perfectly!

Love that it prints perfectly without supports and an easily removable brim. Very satisfying fidget as well after you figure out the solution.

Part tolerances were perfection and it ensures the puzzle stays together.

Much more difficult than expected. Prints perfectly and the solution needs 0 force.

Love these. Great design and prints without supports. The snap together is awesome and the tea fits perfectly

This is definitely the best looking Axelotl on the site. I would recommend putting only the heads on plate 1 so you have access to variable layer height to make the top of the head smoother. the neck pieces won't be seen so I put them with the tongue and nobody would ever know they're red. Otherwise amazing thank you!

Love the look however the seal of the top isn't great. The stationary side that doesn't clamp comes out from time to time letting air in and is a clear weakness in the design. I understand why this was added from printing other coffee clamps that were way more finicky to fit to the bag but ultimately the whole idea is to seal the bag and keep the coffee fresh which I'm not sure it does as well as it could.

Looks amazing and is simple to print. The supports come off very easy and don't leave a trace on the horns which is very impressive!

Perfect! It doesn't take too long to figure out so it's great for cash or small gifts!

Works very well! Can be finicky to get it on the thicker bags but once it's on there it's fantastic!