Turned out amazing. My son loves it.

Gorgeous design. Printed it in silent mode and ot is perfect.

22.5 degree works flawlessly.

Works great, extremely functional. Printed it in translucent light blue PETG and the standard P2S light adds a nice esthetic. I recommend printing longer legs so the front of the AMS is not resting on the glass. Overall, it is a fantastic print.

Works great, extremely functional. Printed it in translucent light blue PETG and the standard P2S light adds a nice esthetic. I recommend printing longer legs so the front of the AMS is not resting on the glass. Overall, it is a fantastic print.

I printed a couple of these for my wife and she absolutely loves them. The insert twirls in there smoothly and has the perfect amount of retention. one of my favorite prints so far.

I used this as an accessory to the "Twist Can Cup" in order to make slim cans function in the standard can holder. It has the perfect amount of tolerences and the dimensions were spot on.

Printed it in PETG so I could do some TPU printing and it worked like a charm. Very stable and smooth.

Absolutely stunning model. The details are incredible, has a decent hefty to it, and came together amazing. I can't wait to print out Sam's other 3 Tie variants.

My son is pretty rough on his water bottle. The bottle was dented and deformed on the bottom so it would wobble worse than I sway and lean while I'm finishing up a 12 pack of IPAs with some whiskey thrown in along the way. A slight breeze would knock it over. A short search resulted in this 3d model and I decided to print it to try and salvage this Owala. The kid has probably like 10 water bottles, but he likes this one the most so it was worth a shot. 95a TPU did the trick, as it was flexible enough to fit over the creases and dents, yet solid enough to maintain a flat bottom. The bottle stands as upright as Keunu Reeves seeing Ana de Armas in Knock Knock. This print is easy enough to remove for washing, yet stays put when you want it to, and like the aforementioned Latina, this bootie does the trick.

The kids absolutely got a kick out of this. Minimal parts to install, flawless print. Amazing design.

Joy Cons fit in perfect, my daughter loves the new controller angle. Works flawlessly!

These printed beautifully. I was a bit afraid I was going to snap them when trying to insert the lower jaw for the smaller ones, but no issue.

Fantastic! I used BL Matte White at 50% speed and the standard .4mm nozzle with the P2S and it turned out absolutely incredible. An LED tealight candle isn't quite bright enough if the room has even minimal light, but a small LED puck light works great.

Excellent model! A little choppy where the white meets the black, but I may try it at 50% speed or with a .2mm nozzle to see how it cleans up. Printed at standard speed with standard P2S nozzle (.4mm) and BL filament.