Sappy

Billrobland

Check out this logo and download my Chain links to go with it.

Michigan Wolverines sports chain

U of M

Neebick

An LCD surround and gridfinity slot combo. This is my second revision which now has a cutout below the LCD so that the clips can be squeezed while removing the LCD. Gridfinity slots are rounded on one side for easier printing. There will be a slight sag on the right side. Double sided tape can be used to secure it to the faceplate but truthfully it is not enough to cause issues.

Gridfinity Faceplate for Bambu Lab P1 Series

p1s upgrade parts

sushibagel

This is just a simple insert to cover the holes in the <a target="_blank" href="https://makerworld.com/models/133452" rel="nofollow noopener">AMS Riser V2 by maCyo42</a> intended for tool attachments. I didn't intend to use the tool attachment holes and preferred to have them covered for a more complete look. &nbsp;I printed them on the side with support material to more closely match the layer lines of my AMS Riser however, it can be printed flat if you desire. There's a small notch at the bottom of the pieces so a flathead screwdriver can be used for easier removal of the covers if desired.

Cut-Out Cover for AMS Riser V2 by maCyo42

riser

Geek Genius Collective

Nebraska Huskers LightboxOriginal example printed with Bambu basic PLA black, white and red. In the pictures there are to areas where there obviously our build plate wasn&#39;t clean from someone&#39;s fingers. Trust us that this is not a model flaw and just an adhesion issue on this test print. I have no reason to print another one at the moment but if we do print another we will update the pictures. We are including two face files with this print as a test, on file has only one layer of black in the face to prevent black wisps as an experiment. The other file has the black in the helmet detail as our normal 0.6mm height as with the other colors. Check out both files if you want to compare the slices and see if you&#39;d want to try it out. The example picture is with the single layer black. As always be sure to heat up your hotend to clean any old filament that is stuck to the nozzle before sending the print. This will help keep color wisps to a minimum.The back has a negative cube included in the objects that you can move and scale as you need for your LED installation.Enjoy and Happy Printing!

Nebraska Huskers Lightbox 

Burra75

6 hole screwdriver holder for insulated Wiha screwdrivers

Wiha Screwdriver Holder

workshop

France

It is nice to have at a desk. Easy print took me 30ish minutes to print. Make sure to take off the top layer in the slicer so you can see the infill. You can change the infill to customize the print.

U of M

p1s upgrade parts

riser

tom

workshop

Tammi