thank you for the print ! the eyes were a struggle so I just didn’t add the other color to the other and just glued that and looks fine without the black :) thank you! but please if able scale down eyes a little to fit better I even tried hammering it with the back of my 1 1/4lb ax and still couldn’t get it in all the way while also smooshing the back spikes a little from the pounding 🤣(purple one) thanks again friend! I do also see others in comments talking about the eyes so I see now it wasn’t just me not understanding 🤣 appreciate it !!

absolutely love it, did a great job making this :) thank you for making it happen, as I’m a long time eeve lover :) friends I’ve shown have been in awh, you’ve done well and I thank you again :) - made with by P2S -

thank you so much for making this possible!! made for as a gift for my brothers girlfriend deep into the life of Harry Potter, I’m sure will make a lot of smiles happen! I appreciate it, thanks again friend ! :) - made with by P2S -

wonderful job making this, friend :) I appreciate it greatly as I’m sure my girlfriends nephew would agree as it was a gift for him :) thank you for taking the time to produce the link, you’ve made some smiles happen and hope you have a wonderful day and life in the 3D world :)

thank you !! I love the outcome of this print and didn’t take long at all! appreciate it and the time you took to make :) great job, friend. :) it was a gift to my girlfriends nephew , I apologize as I forgot to take a picture of it separate from the figure I made. thanks again friend :) (any reference should refer to the figure leaning against the bigger pika’s tail)

thank you!! made it for my girlfriend’s grandma, turnout wasn’t too shabby! thank you for making that happen I appreciate it ! -made on p2s-

this was the first piece project I did, and I think you did a fantastic job making it friend :) thank you for the link, I appreciate it! it’s now one of my showpieces in my living room :) I didn’t realize I was supposed to shave the head out and use blocks to not use glue until I made something else and revisited this in confusion hahaha but that’s on me not you, I think it turned out great and appreciate you for making it possible :)

great job friend :) only reason it didn’t work the first time was because of my own fault and bed adhesion, other than that it worked great ! :) used a sparkly purple and glow in the dark eyes for my nephews and I’m sure they will love it! I did however give my brother a square of sandpaper due to the nose appearing as sharp as it is but that’s the way the Dino should look in any case :) thank you again; you did great making :)

big fan of this, and everyone I’ve shown has been impressed with the toy as well, as I did put the magnet’s in as well. I only would suggest to the creator to make them a little bigger of magnets , as these do magnetize to eachother but not very well due to them being so small and weight of the filament is greater than such and I also have the other side a little taped due to I believe the spring pushing a little hard but that’d be my own fault for not cutting the spring down any as suggested. at any case, I give it 5* that’s mearely a suggestion the rest of the work is fantastic and fun :) made it for my brother and I’m sure he will appreciate it, thank you again friend

great job making this , made a bunch for the little ones for Easter as I have almost 10 nieces now :O, I appreciate it ! thank you!! I’m sure they will love :)