Could not find a DJI FPV protector so desgined this one

Made my first very own vase in Freecad. Print it as it is becasue the angles are too steep for vase mode / spiral vase. Please comment what you like / dislike about the model :)

Simple nozzle organizer with thread for the four most used sizes. Easy print except the thread is a little tight. Recommended to screw a normal M6 bolt in and out of every hole, or use a thread set to turn the nozzles easily in by hand. otherwise just use the tool and it will also works fine.

Could not find an easy and fast usable mount for my hygrometer, to place inside of a IKEA Samla storage box for my filament. This Mount+Clip does not require any magnets, screws or magnets to function. Prints in a few minuts with less than 3 grams of filament. Just remove the support carefully, file a little and pop the parts together and click it inside the box. Made the clip really thin because I use the gasket created by jr2142 Thanks btw it is awesome!

I was annoyed by oil spillage while filling my lubricant containers, because I could not find a small enough funnel to fit inside the tight hole of these containers so I designed one to make life easier ;)

Designed a Tee to tryout on the golfcourse! I cutted the part on the bottom to show a name / brand but this is not necessary to print the part successfully.