Roxelchen

Hollingsworth Design

<h3>Stackable Sorting Trays in 3 Sizes</h3>&nbsp;A set of stackable/nesting trays for all your sorting and storage needs. These are an easy print and are great for puzzles, arts and crafts, screws/hardware, and much more. The tray design is very durable due to the wall thickness of 2.0mm and floor thickness of 1.4mm. Sizes and approximate filament usage is as follows:<ul><li>Small (125mm x 125mm): ~50g PLA</li><li>Medium (250mm x 125mm): ~88g PLA</li><li>Large (250mm x 250mm): ~150g PLA</li></ul>&nbsp;Notes<ol><li>If you plan on printing the Large size on a Bambu Lab X or P series printer, you will need to follow the directions here to open up the full X-Y printable area: <a href="https://wiki.bambulab.com/en/knowledge-sharing/print-volume-limitations" rel="nofollow">https://wiki.bambulab.com/en/knowledge-sharing/print-volume-limitations</a></li><li>This design uses a stackable lip inspired by the Gridfinity project - credit for this goes to <a href="https://thangs.com/designer/ZackFreedman" rel="nofollow">Zack Freedman</a></li></ol>

Stackable Sorting Trays in 3 Sizes

Storage

To Print

Printer Maintenance

DesignCraft

DISCLAIMER: Print profiles NOT created by DesignCraft may contain outdated model versions or suboptimal slicer settings. Use at your own risk! I have no control to moderate or remove these third party print profiles.&nbsp;The Sunlu v2 print profiles include the latest models for this adapter system. The models have been updated to include the <a target="_blank" href="https://amzn.to/3QIOVEk" rel="nofollow noopener">SUNLU</a> nameplate and also reduce the amount of material needed for each print. Please refer to the Disclaimer above and also please read the Considerations section below.&nbsp;Description:<ul><li>This model widens one side of the spool ring adapter to stabilize a SUNLU 1kg 195x60mm spool while it rotates within a Bambu Lab AMS. </li><li>I've tested these adapters on SUNLU PLA and SUNLU PLA Meta spools. I have not tested on SUNLU PLA+ and some people have reported that the PLA+ spools are larger. Please measure your spool before printing.</li></ul>Instructions:<ul><li>Print one of each model for a single spool.</li><li>Affix the wide spool ring adapter on the right-hand side of the SUNLU spool if you're facing the AMS.</li><li>See attached photos.</li></ul>Considerations:<ul><li>Print Material: Please print with a basic PLA or PETG to minimize any shrinkage.</li></ul>

SUNLU Bambu Lab AMS Spool Adapter Ring

AMS Adapters

Aruba3D

educational game to improve hand-eye coordination, imagination and logical reasoning. Each circle can be associated according its color and the number of fractions. The board includes from 1 to 6 fractions.

Fraction puzzle

Education