The toilet printed out quite well except for a few overhangs. But the pig, see the photo. The butt is wrong but it will be on the bowl so it's ok and under the neck and snout it turned out like this.

Super B print profile. THX.

Super spider. THX

Printed well. I only used the longest rod which I printed twice.

Nice profile, my granddaughter put it together with my help. We will print more monsters :).

Very nice.

Clean print. Nicely cast and quite big. Just turns more to the right but I'll probably have to adjust some of the area on the wing. Tried it inside but today we're going to go outside with my granddaughter.

Nice fun. My granddaughter and I had a lot of fun, but we cheated a little, we watched the 4 parts being put together and then put them back together :).

Great little box for my scattered batteries :). According to some comments, the lid didn't fit. So I modified it and added a front side so it was completely closed.

all ok

Beautiful lamp, printed so that I reduced it but I didn't notice that everything was reduced :) and so it didn't fit in the base. So I printed it again and then printed a smaller base on the reduced one.

I have printed a great frame for my Selphy 1300 printer several times.

Great, but who will teach me how to play? :)

All ok.

My first more demanding print. Everything turned out to my satisfaction. I didn't print the pins with PETG but with PLA and it was absolutely fine. Instead of KIT 001, I used a 70% cheaper LED from Aliexpress. It fit well. I had to glue the bottom legs with superglue because they were falling out. The lamp looks fantastic and I am very satisfied. Thank you very much for the work you did.

All ok.

Printing went without a problem. Beautiful design. The wife is satisfied. Thank you.

Printed without any problems. I installed the paste and it works great. Thanks.