the hands are a bit thin and very easily breakable. it would be better if they are a bit thicker but since I’m a newbie, I didn’t know how to fix this issue yet.

I had a problem with one of the supports that was not complete around the flap where the phone would sit. It came off of the plate and ended up being a bit distorted around the edge after I put it back on the plate because the brim was incomplete in the file, although all the rested came out really nice! plus, the supports wouldn’t come off easily.

The print finish depends on the type of filament used. Sometimes it messes up the print in the final stages and sometimes the parts break and disconnect from each other.

The design is unique but the temples are very loose and need stoppers to prevent them from opening all the way to the back.

super cool but even if you can close the temples, they are a bit loose.

I only wish the temples were foldable. I had to apply superglue to prevent them from falling incessantly.