Ricecakes3

JDJDJD

<h2><img src="https://makerworld.bblmw.com/makerworld/draft/693332/2023-10-20_f597d805fa3e9.gif"></h2>The TopProp is very stable and thoughtfully designed to prop your glass lid open for venting.&nbsp;Venting is recommended by Bambu Lab in many situations, for example when using PLA on the Textured PEI plate and Smooth PEI plate.&nbsp;The TopProp provides 30 inches of venting across the top of your machine.&nbsp;Featuring a stylish design with the perfect angles for supporting your glass top, TopProp also includes a handy magnetized hanger making use easy, quick and enjoyable.&nbsp;<ul><li>No Brims</li><li>No Overhangs</li><li>No Supports</li></ul><h3> </h3><h3>Magnets:</h3>Magnets can be easily pressed into place. Several magnet diameters are supported and can be up to 7mm in height.&nbsp;<ul><li>10mm diameter magnets</li><li>8mm diameter magnets</li><li>6mm diameter magnets</li></ul>&nbsp;<h3>Print Orientation Requirements:</h3><ul><li>TopProp: Side on bed</li><li>TopProp Hanger: Large flat side on bed</li></ul>&nbsp;<h3>Tips:</h3><ul><li>The side of the machine has some internal metal components that work with the magnets. The best locations on the sides are near the front and back corners (see image examples). However, if you want your TopProp even more secure you can simply use a small loop of gift wrapping tape on the backside of the hanger in conjunction with the magnets. It’s best to install the tape with the open ends of the looped tape facing up and down (vs side to side). This prevents the tape from rolling.</li><li>Magnets can be stacked up to 7mm in height for added strength.</li><li>I don't set my AMS on top of my machine, instead I use a shelf above my printer. Extra weight on top raises the center of gravity and can create a swaying effect. As such, this is designed around no AMS on top. It's also possible to print two TopProps and use them on the right and left corners - they fit there, too.</li></ul>

TopProp - Lid Lifter Vent For Glass Top

For Printer

squinn

A portable cable organizer which is setup as an easy print-in-place and includes a knob on the side for conveniently winding up the cable when you're ready to pack it away.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_fd01d80e216de.gif"></figure>This model is an easy print that requires no supports, and three different sizes are provided to accommodate cables of different lengths. If you're not sure which to choose, I'd recommend starting with the “medium” size.&nbsp;After printing, you'll want to place the cable within the groove at its halfway point, close the lid (which is intentionally designed to close tightly), wind up the cord clockwise using the handle, and then extend by simply grabbing the cable by both ends.&nbsp;Update 2023-09-13:&nbsp;Alternative smooth-sided versions of all three sizes have now been added, and also the handle design was slightly adjusted to add a small fillet and chamfer to decrease the bridge distance. Here's a close-up picture of the updated handle on the knurled and smooth-sided versions:<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_e75ea621224d08.jpg"></figure><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_68f2b35a6774b8.jpg"></figure>&nbsp;

For Printer

storage