Search models, users, collections, and posts
Bio
Been tinkering with the Ender 3 for years and finally decided to take the plunge on the P1S. I can see what all the fuss was about!
Achievements
Stellar Reviewer
Rate or Comment 204 different models
Pioneer Maker
Print successful 160 different models and 1,278 hours
MakerWorld Guardian
This badge has expired
Printed well in generic silk PLA. Will have to let the kids test it out, but it might benefit from being a bit thicker.
Share
0
0
0
Share
0
0
0
Printed well with Sunlu PLA+, except the corners were lifting from the plate. Might need some tabs or brim to keep it in place.
Printed the lids in Bambu PETG HF, but it might need some supports to help with the bridging.
Share
0
0
0
Printed very well in generic blue silk PLA.
Btw there are two small holes at the back where a cylinder was used to cut out a negative part of the model.
Share
0
0
0
Printed very nicely with Sunlu PLA+. The smaller version is great for a few pens and prints much faster.
Share
0
0
0
Printed well in Sunlu PLA+. Supports easy to remove and briefly flamed the scars with a lighter.
Share
0
0
0
Nice solid design and easy to print. Used some cheap generic silk PLA and it printed with no issues.
Share
0
0
0
Share
0
0
0
No more data