These were a pretty easy print overall, I resized the pins to 98.5% and resized the sleeve that goes over the longer pins to 101%, if you dont do that everything is way to tight and doesn't go together without having problems. When putting the pins in i did use some glue to hold them in. It has been working great, I love it, there is enough room on the lower ams to open the lid fully without having to pull it out just stagger the top one back by maybe an inch.

WORKS GREAT AS INTENDED, BUT IT DOES COVER UP THE LIGHTS (SOMETHING I DIDNT THINK ABOUT), NOT A BIG DEAL THAT IT COVERS THE LIGHTS, JUST LIFT IT UP FOR A MOMENT AND YOU CAN SEE IF ONE OF THE LIGHTS IS BLINKING RED OR WHITE. BUT MAKES IT SUPER EASY TO SEE WHICH SPOT IS WHICH.

Great print, love that Snoopy is on it, only thing i would recommend is a change in the lid, currently there is nothing there to keep the lid in place, it moves around easily, needs an edge to sit in for a more firmer fit.

Great print, easy to make with minimal color changes. I just scaled it a little larger to about 140%. Looks great with a tea light in it.

I give it 4 stars, it's an easy print with the exception that the pins don't fit and need to be resized.

Wing tips are pretty sharp and pokey, otherwise a great print.

I really like that I had the choice to print each part separately rather than using my ams, much quicker to print that way and uses less filament.

At .24 layer height, print quality was extremely poor, parts of it was not even adhering to the build plate; switched to .2 layer height and it printed beautifully with no problems.